12
cramer.eu
PROBLEM
PROBABLE CAUSE
SOLUTION
Mower is
not bagging
properly.
Cutting height is set
too low.
Raise the cutting height.
Wet grass clippings
are sticking to the
underside of the
deck.
Wait until the grass dries before
mowing.
Mower is
vibrating at
higher speed.
Blade is unbalanced,
excessively or
unevenly worn.
Replace the blade.
Motor shaft is bent.
Stop the motor, remove isolator
key and battery, disconnect the
power source, and inspect for
damage. Have it repaired by an
authorised service center before
restarting.
Motor stops
while cutting.
Cutting height is set
too low.
Raise the cutting height.
Battery has no power.
Charge the battery.
EN
Troubleshooting
PROBLEM
PROBABLE CAUSE
SOLUTION
Handle is not
in position.
Carriage bolts are not
seated properly.
Adjust the height of the handle
and make sure the carriage bolts
are seated properly.
Mower is not
starting.
Battery is low in
charge.
Charge the battery.
Battery is either
inoperable or will not
take a charge.
Replace the battery.
The safety key is not
inserted.
Insert the safety key.
Mower is
cutting grass
unevenly.
Lawn is rough or
uneven or cutting
height not set
properly.
Move the wheels to a higher
position. All wheels must be
placed in the same cutting height
for the mower to cut evenly.
Mower is
not mulching
properly.
Wet grass clippings
are sticking to the
underside of the
deck.
Wait until the grass dries before
mowing.
Mower is
hard to push.
High grass, rear of
mower housing and
blade are dragging
in heavy grass, or
cutting height too
low.
Raise the cutting height.
* If the fault is not solved, you must go to your distributor and/or nearest Authorized
Technical Service.
Summary of Contents for 2500386
Page 320: ...DISTRIBUTOR INFO cramer eu ...
