12
cramer.eu
EN
* If the fault is not solved, you must go to your distributor and/or nearest Authorized
Technical Service.
Motor
runs, chain
rotates but
does not
cut.
Dull chain.
Sharpen or replace the saw
chain.
Chain on backwards.
Refer to Replacing the Bar and
Saw Chain assembly earlier in
this manual.
Chain tension could be
overtightened or too loose.
Refer to Re-tensioning the saw
chain in the manual.
Chain saw
does not
start.
The chain brake is engaged.
Pull the chain brake towards
you until the chain brake is
disengaged.
No electrical contact
between the chain saw and
battery.
To secure the battery, make
sure the latches on the battery
compartment snap into place.
The battery pack is
depleted.
Charge the battery pack.
The lock-off lever and
trigger are not depressed
simultaneously.
Press down the lock-off lever and
hold it, then depress the trigger
to turn on the chain saw.
The battery and power tool
is too hot or too cold.
Refer to the battery and charger
maintaince part in the manual.
Motor
running,
but cutting
abnormal.
Motor stops after about 3
seconds.
Recharge the battery.
If the unit cuts off and
beeps during a cut, it went
into protection mode. This
protects the PCB from
damage.
Release the trigger and restart
the chain saw. Let the chain saw
do the work and do not force
the cut.
Battery is not charged.
Charge the battery. Refer to the
battery and charger manual for
correct charging procedures.
The saw chain needs
lubrication, and will increase
friction if not properly
maintained.
Make sure the chain is always
lubricated by never letting the bar
and chain oil run low.
Incorrect battery storage
temperature.
Allow the battery pack to
cool until it drops to room
temperature.
Summary of Contents for 40CS12
Page 310: ...DISTRIBUTOR INFO cramer eu ...
