English
Sweeper
Original Operation Manual
-16
10
Installation of sweeping brushes, installation of side covers
Safety
Delivery, packaging, assembly
CAUTION!
Squeezing hazard during assembly
Parts of the body may be squeezed when
components are assembled.
Wear close-fitting clothing and protection
gloves during assembly.
Risk of high dead weight
• The machine must not be lifted manually.
• Pull the machine off the transporter at its handles.
• Remove machine parts separately from packaging.
Perform transport inspection
• Check the machine for completeness and potential damage upon delivery.
• The machine shall be supplied to the specialist dealer in a partially assembled
condition.
• Assembly and start-up have to be performed by a specialist dealer and/or an expert
in this field.
Packaging
• Please dispose of packaging materials separately.
Installation of support wheel
Installation
The support wheel (2) must be attached to the castor
receptacle (1) by means of the enclosed nut M12. By
using a mandrel Ø 5mm or something similar, the castor
may be fixed on the borehole (3).
Assembly of sweeping brushes
Overview
Right brush
installation
1. Right brush overview
1. Right brush
2. Washer
3. Washer with nibs
2. Press-fit the washer with nibs
(no. 1) into the hollow body
recess of the right brush.
Lightly hit on it as needed.
3. Press-fit the washer (no. 2) in
the recess on the outside of the
right brush.
1. Washer with nibs
2. Washer
3. Recess
