REMOVING A SPIRAL MOTOR
* Place the Tray in the loading position. See
S-l
* Disconnect the Motor Harness. See
s-11
* Remove the Spiral. See S-5
* Remove the Spiral Coupler. See S-6
* Lift the Motor clear of the Tray.
INSTALLING A SPIRAL MOTOR (See Figure S-12a)
* Place the Tray in the loading position. See
S-l
* Place the Motor in the correct position at the rear of the Tray.
* Place a Gear in position if required by this set-up. See
S-8
* Install a Spiral Coupler. See S-9
The Spiral Coupler
holds the motor
in place.
Figure S-12a
* Connect the Motor Harness. See s-11
Exit
Summary of Contents for 147
