Crane 99481, User Manual

16

17

en your knees at the bottom of 

the pedal stroke. 

(see

Fig. F)

.

5. Connect the upper sensor wire 

20

with the center console 

22

. 

Fasten the handlebar 

4

 to the upper 

part of the rear main frame 

2

 using 4 

hex screws 

12

, 4 spring washers 

13

, 2 

washers 

14

 and 2 curved washers 

17

(see

Fig. G)

.

NOTICE!

Make sure that the cable is not 

crushed during assembly.

The X-Bike is now fully assem-

bled.

NOTICE!

Leveling

Adjust the X-Bike so that is sits 

on the floor without rocking.

Using the LCD screen

Inserting and replacing 

batteries

1. Open the battery compartment on the 

bottom of the LCD screen 

22

(see

Fig. H)

.

2. Remove any used batteries from the 

battery compartment. Observe the 

disposal instructions for batteries on 

page 20.

3. Insert the two supplied AAA 

25

batteries into the battery compart-

ment according to their polarity. 

4. Close the battery compartment.

Hand pulse sensors

PULSE MEASUREMENT: You can measure 

your pulse using the two hand 

24

 sensors on the handles

4

.

-  During the workout, place both hands on the hand sensors 

24

 on the handles 

4

and wait briefly until the heart rate is displayed on the LCD monitor 

(see

Fig. I)

. 

WARNING!

Heart rate monitoring systems may be inaccurate. Over exercising may result in 

serious injury or death. If you feel faint stop exercising immediately.

STOP MODE

-  The display on the center console will enter SLEEP mode (LCD off) when there is no 

signal input or after 4 minutes without pedaling.

Functions and Features

1. SCAN: 

Press the MODE button until SCAN appears on the screen. 

The following functions will be displayed for 6 seconds each on the main screen: 

TIME---SPEED---DISTANCE---CALORIE---ODO---PULSE. If the display is faint or shows 

no figures, please replace the batteries.

2. TIME: 

Shows your elapsed workout time in minutes and seconds. Your computer 

will automatically count up from 0:00 to 99:59 in one second intervals. If you 

continue exercising once the time has reached 0:00, the computer will begin 

beeping, and count up from 0:00.

3. SPEED: 

Displays your workout speed value in KM/MILE per hour from 0.0 to 999.9.

4. DISTANCE: 

Displays the accumulative distance traveled during each workout up to 

a maximum of 999.9 miles.

5. CALORIES: 

Your computer will estimate the cumulative calories burned at any 

given time during your workout.

6. ODOMETER: 

Will display the total accumulated distance of the Foldable Exercise Bike.

Using the LCD screen

20

14

13

12

17

4

22

22

20

2

 G

Hand pulse sensors

20

14

13

12

17

4

22

22

20

2

 H

 I

24

24

4

22

 F