Crane BevMax 4 Technical Manual Download

Page: 7 / 103

DO NOT

REMOVE THE GROUND

PIN ON THE PLUG OR IN ANY WAY
BYPASS, MODIFY, DEFEAT, OR
DESTROY THE GROUNDING
SYSTEM OF THE VENDING
MACHINE

•

DO NOT USE WITH AN EXTENSION CORD.

•

DO NOT

REMOVE THE WARNING TAG

ATTACHED TO THE POWER SUPPLY CORD.

•

The GFCI must be tested frequently and before

each use in accordance with the instructions
provided on the GFCI device.

IF THE GFCI

DOES NOT PASS THE TEST, DO NOT USE
THE MACHINE

. Unplug the supply cord from the

receptacle and call the Crane Merchandising
Systems Technical Support Group for assistance
at 1-803-266-5001.

It is recommended that the machine be located so that
the GFCI device will be accessible after the machine
is installed. After installation, visually inspect the
GFCI and power supply cord to be sure it is not
crushed, pinched, or stretched.

Protect the power supply cord during transportation
and use. Periodically inspect the power supply cord
for damage. If the cord or plug is worn or damaged, it
must be replaced with a power supply cord of the
same type, size and specification as originally
provided with the machine.

NOT USE THE

VENDING MACHINE UNTIL THE WORN OR
DAMAGED CORD IS REPLACED.

FAILURE TO COMPLY WITH
THESE INSTRUCTIONS MAY
SUBJECT THE USER TO THE RISK
OF INJURY OR ELECTRICAL
SHOCK WHICH CAN BE SERIOUS
OR FATAL. PERIODICALLY
INSPECT THE POWER SUPPLY
CORD FOR DAMAGE. IF THE
CORD BECOMES DAMAGED IT
MUST BE REPLACED WITH THE
SAME SIZE AND TYPE CORD.
CONTACT CRANE
MERCHANDISING SYSTEMS FOR
ASSISTANCE.

INSTALLATION AND SETUP
INSTRUCTIONS

ELECTRONIC LOCK

The electronic lock provided in the vender consists of
a door mounted, motor driven 2 point latching system,
cabinet mounted latch and strike system, an infrared
controlled CPU, and a remote control key (FOB). The
design is modular and allows for easy field service.

The electronic remote key (FOB) features a rolling
code system which cannot be decoded if it is lost or
stolen. After the vender has been unlocked, a new
key can be programmed into it any number of times.
If a key is lost or stolen, it is recommended you
change the lock code in the field as soon as possible.
Changing the lock code requires a new key and
pressing the PROGRAM button on the lock inside the
vender. The lock does not need to be changed for re-
keying.

Important:

For security reasons all Electronic

Door Lock Venders are shipped less
keys. Customers will need to contact
the Electronic Door Lock
manufacturer to order keys.

A power bypass connector, located in the product
delivery port, allows auxiliary power to be applied via
a battery pack to the electronic lock in the event that
power is not available or there has been a failure of
the internal power supply. In the event of an
emergency, battery power is applied to the connector
and the door can be opened and closed using the
FOB.

The electronics uses an infrared transmission system,
which functions similar to a television remote control.
The transmission signal is line-of-sight, which requires
you to aim the remote at a specific place at close
range to prevent the accidental opening of several
venders at the same time.

TO OPEN THE ELECTRONIC DOOR LOCK:

1. Plug the vender into a properly powered

outlet.

2. Hold the key FOB 0 to 3” (76.2 mm) in front of

the Delivery Port Door and press the button
on the key FOB.
Note: The wide end of the FOB should face

the door.

The lock will begin releasing the door. The
display will indicate

OPENED.

After the motor

has stopped running, you can pull the door
open.

TO CLOSE THE ELECTRONIC DOOR LOCK:

CAUTION: DO NOT SLAM THE DOOR CLOSED.

Slamming the door closed can damage the electronic
locking device.