BevMax_Media_Programming_10_6_10 Page 17 of 106 08/15/2013
Error
Description
Probable
Cause
Possible
Solutions
Factory Init.
An attempt to restore factory default settings has
Power down, power up, try again.
been unsuccessful.
Power down, remove monetary devices and try again.
Replace the control board and reset.
Card Reader No Comms.
The control board is not able to communicate with
Check connections for the card reader.
the card reader.
Check for damage to the harness (cut, pinched, etc.).
Replace the card reader.
Reset the control board.
Replace the control board.
Card Reader Comms Error.
The control board is not communicating with the
Check the connections and harness for damage.
Card reader.
Check the settings on the board and on the reader.
Replace the reader.
Reset and/or replace the board.
Bill Validator No Comms.
The control board is not communicating with the
Check the connections and settings for the validator.
bill
validator.
Replace
the
harness.
Replace the validator.
Bill Validator Motor Error.
The validator has reported an error to a drive motor
Check for a broken belt or blockage.
within the validator.
Replace the bill validator.
Bill Validator Sensor Error.
The validator has reported an error to a sensor within
Check for a sensor blockage.
the
validator.
Replace
the
bill
validator.
Bill Validator ROM Erro.
An error has been detected in a main chip in the
Replace the bill validator.
Validator.
Bill Validator Acceptor
A jam in the bill path has been detected.
Check the bill path for items that are blocking sensors.
Jammed. Check
to
see
that
the
bill
path
gates
are
not
open.
Replace the bill validator.
Bill Validator Stacker Error.
An error has been reported concerning the bill box.
Check the bill box to be mounted to the validator
properly.
Replace the bill box.
Replace the bill validator.
Bill Validator Stacker Full.
The bill validator is reporting that the bill box is full
Check for bills and remove them.
of
bills.
Replace
the
bill
box.
Replace the bill validator.
