BevMax_Media_Programming_10_6_10 Page 73 of 106
08/15/2013
GSM APN: is the Access Point Name used by the GSM radio.
GSM User: is the username used by the GSM radio.
GSM Password: is the password used by the GSM radio.
Zigbee Pan ID: is one of the Zigbee parameters that identify the mesh network.
Zibgee Net Key Seed: is the other Zigbee parameter used to identify the mesh network.
5. Press the 5 Key to Load Network Configuration.
If the “Flash stick not found” message is displayed, the system
cannot detect that a USB stick has been inserted into the Atlas board.
Make sure the USB stick is properly formatted and contains an /atlas
folder.
BevMax/Merchant Media
Intergraded Wireless Radio Setup
Cashless / Remote DEX / Alerts
1.
Heartland / Streamware Acct - Before installing the radio for intergraded wireless function, you must
establish an account with Vantiv or Heartland Payment Systems and Crane Streamware.
A.
When the customer account is established, Crane Streamware will email the customer a
configuration file for uploading and assigning the BevMax Media (referenced as BMM below).
2.
On the BMM, check/load the Control Board software. It should be version 10.6.10 or higher.
3.
On the BMM, check/set the current Time and Date.
4.
Make sure the machine fully operates and vends product before proceeding.
5.
On Control Board, make sure J27 has a jumper across pins 2 & 3.
6.
On the BMM, set cashless reader to “Onboard Reader”
A.
In Service Mode, go into Monetary Menu.
B.
At Cashless Reader, select “Onboard Reader”
7.
Radio Installation
A.
On the BMM, turn OFF the power switch.
B.
Connect the USB cable between the Radio and USB1 on the Control board.
USB1 is located at top left of other two USB sockets facing the board.
*** Very Important ***
The Radio will only work in USB1, not USB2 or USB3.
C.
Connect the antenna’s to the Radio
D.
Velcro the Radio assembly against the cover panel of the control board.
E.
On BMM, turn ON the power switch.
F.
Within a couple of minutes the LED on the radio should flash or stay lit.
G.
Neatly route and tie wrap all the Radio cables in order to prevent them from catching/pinching
when closing the monetary panel.
8.
Download the customer configuration file on the memory stick.
A.
Use a blank USB memory stick and plug it into your computer.
Load Network Config
Flash stick not found.
