BevMax_Media_Programming_10_6_10 Page 74 of 106
08/15/2013
B.
When account and machine information is established by Vantiv or Heartland and Streamware,
they will email the following customer configuration file: “VixConfigData.cfg”.
C.
Open up the computer drive where the USB memory stick is inserted.
D.
Create a new folder called
“atlas”
on your blank USB stick.
E.
Copy the emailed file “VixConfigData.cfg” and paste into the
“atlas
” folder.
9.
Check Radio signal strength –
A.
In Service menu, press ‘0’ for “Telemetry”.
B.
Press line number for “Show Network Status”
C.
The first line should show
Node Type
: “Gateway”. If it shows “Client” the radio is not
communicating the with board.
D.
Check the RSSI parameter line on screen. If the signal strength is very low (above -100 DB), you
might consider switching to a different radio type (i.e., GSM vs. CDMA or vice-versa).
10.
Assigning Telemetry:
A.
Depress the Monetary Panel interlock switch and wait for security pin entry to appear on display.
Enter four digit pin (factory default = 3333).
B.
Insert USB stick into any open USB port on control board.
C.
At Service Menu screen, press the ‘O’ button for “Telemetry”
D.
In Telemetry screen, press #1 for “Assign Unit”
E.
The Control Board should now update the customer information from the memory stick. Once this
is complete, the BevMax Media will reboot (reboot will take 5 -7 minutes.).
(Note: Wait at lease 5 minutes to fully allow upload and reboot.)
F.
The following screen should appear:
•
Press 1 and enter the machine ID
The Machine ID Keypad will be similar to a text type phone that does not have a full keyboard.
Press i button to change the keypad character function from Numeric / Alpha: Upper Case / Lower Case.
Example machine ID 34585 (p= pause for .5 seconds):
Press
button twice. Press 3p 4p 5p 8p 5 then
OK
on the Keypad.
Example machine ID ABC123:
Press
button once. Press 2p 22p 222p then
once. Then 1p 2p 3 then
OK.
