Crane EE-5063, Instruction Manual

GENERAL MAINTENANCE AND CLEANING  

Before any cleaning operation, switch the humidifier off and unplug it.  

1.

Always unplug the unit before cleaning. 

2.

The humidifier must be drained and cleaned before storing. 

3.

Once unplugged the exterior of the unit may be cleaned by wiping with a dry cloth. 

Caution: The ON/OFF switch must be thoroughly dry before unit is again plugged 
into power source. 

4.

There may be some lime deposits in the nebulizer, particular in areas with hard 
water. Overcome this drawback by cleaning the nebulizer with water and vinegar on 

a soft cloth regularly, as follows:  

A.

Dampen a cloth with vinegar and wipe the nebulizer gently, until the lime 
deposits disappear completely.  

B.

Rub down gently with a dry cloth and remove remains of humidity.  

C.

Do not rub the nebulizer with solid objects.  

D.

Do not clean with chemical products 

5.

When cleaning the water basin do not place the nebulizer directly under the water 

tap. 

6.

Never immerse the unit in water or let water enter the fan vent (see figure 3) or 

any other openings. 

7.

It is normal for water to be in the water basin. However water must not get inside 
the central body.  If this should happen, take the humidifier to an authorized service 

center before using it again.  

8.

Clean the inside of the water tank at least once a week, as follows:  

A.

Fill the tank with clean water adding a few drops of bleach. Close the tank 
completely with its cap and shake by holding the tank with both hands. Do 

not hold by handle while shaking the tank.  

B.

Rinse thoroughly.  

Note:  Water accumulated over long periods may create bacteria and mildew (fungus).  
It is important to remove the water in the humidifier if the humidifier is not being used.  
Always use fresh clean water when filling the water basin. 

9.

To clean the water float remove the plastic cap on the pin by pulling it up (see 
 Fig.12). Remove the water float and cap and clean by wiping the parts with a soft 

damp cloth. Replace the parts by first putting the water float onto the pin and then 
pressing the plastic cap on the end of the pin to secure the float.(see Fig.13). Do 

not use excessive force. 

Plastic Cap 

Fig. 11

Fig. 12

Fig. 13

9