51
ADDITIONAL INFORMATION & FEATURES Section 4
WIRELESS
WIRELESS
WIRELESS
WIRELESS
WIRELESS
Wireless is switched on in Comms Setup by selecting RF. RF module is initialised
and will get a flashing ‘R’ in bottom left hand corner of display while it is on.
(Note: RF must be on)
CHANGE RF ID
It is now possible to configure the wrench RFID address on the wrench itself. This
will make it easier to swap a wrench over for another. To change the RFID perform
the following. The change to RFID is performed in Setup so only a Superuser is
allowed to perform the change:
Ensure in Main Menu by pressing Red key (several times).
Use down arrow key to go to Setup and select with Green key.
Use down arrow key to go to Comms Setup and select with Green key.
Use down arrow key to go to RF ID and select with Green key.
The current RFID will be displayed.
You can edit the value between 01 and FF and pressing Green key will save
changes.
At present it is necessary for the wrench to be power cycled for the new RF
ID address to be used.
Pressing Red Key 3 times will bring the user back to Main Menu.
This function is in setup so only a Superuser can perform a change.
This function is in Comms Setup as the wrench must be set in RF wireless mode (‘R’
flashing in bottom left corner of display).
The user can confirm this address by entering Comms Setup / RF Comms / RF
Configuration
Press the Green
key to get the message
‘sending .... GEN Mode 0’
Press down arrow to access GEN DEVICEADDR xx -> where XX is current RFID
The flashing ‘R’ will disappear if RF is switched off.
RF stays on for the period of the Wireless Auto Off timer set in Power Settings. This
timer is reset if a torque is pulled, there is communication, or if a key is pressed.
RF function will be switched off if get a low battery warning in order to conserve
power. So if a
symbol is displayed, replace wrench in to cradle to charge battery.