62
ADDITIONAL INFORMATION & FEATURES Section 4
GLOSSARY OF TERMS
Angle threshold
This is the value that the torque must rise above to start the angle
measurement.
Angle limits
The upper and lower limits for the angle application. Displayed as an actual
value or a percentage of target.
Any Order
The jobs can be used in any order.
Auto Print
Automatic printing of the torque value, second parameter, and duration.
Via selected comms port to serial printer or RS232 terminal emulator.
Auto Fault Prompt
Facility to indicate cause of fault and corrective action to be taken against
a low or high reading.
Audit Algorithm
This is a special software algorithm that senses the break away point of
the tightened fixing and displays the torque value after a defined number
of degrees is reached.
Configure
The process of entering and storing the basic parameters which determine
the resulting outputs of IQWrench2 Opta.
Control Limits
The upper and lower limits for the torue appication either side of target
indicating tool or process is out of control.
Cycle End Time
Is the time the torque must be below threshold for the reading to finish.
Timer is reset if torque goes above threshold.
Settings are 0.1; 0.2; 0.5; 1.0; 2.0; 5.0; 10 secs.
If being used with ratchet, it is best to use larger cycle end time.
Current Fault
Is the last fault indicator assigned to the last low or high reading.
Direction
The direction in which the wrench is turned to apply torque - Clockwise (right)
or Anticlockwise (left).