66
ADDITIONAL INFORMATION & FEATURES Section 4
Vertical plus Prompt
Identical in procedure to that of Vertical mode except that before stepping to
the next Job, IQWrench2 Opta will prompt for the rest of the job to start and
will require the ENTER key to be pressed.
UCL
The Upper Control Limit as set in the Setup parameters. (if control limits
enabled)
Units
It is possible with IQWrench2 Opta to measure torque, and convert internally
to display and store in any of the other torque measurement units as speci-
fied.
Units available - Nm; kgfcm; kgfm; lbin; lbft; Ncm.
Will only display in units that allow torque to be displayed in 4 significant
figures for that span of wrench.
USL
The Upper Specification Limit as set in the setup parameters.
2
nd
Parameter
A second set of values for measuring either torque or angle at the
same time.