Merchant™ Operators’ Guide
Initial Setup
1810025
11
August 2009
Positioning the Merchandiser
WARNING
This merchandiser is only rated for
installation in an INDOOR location.
Move the merchandiser to its
approximate position
. (There are some procedures you need to do
before it is in its permanent location.) Plug in your merchandiser and turn the power switch to
ON.
•
You can position this merchandiser anywhere in a bank of machines. It can even be placed
on an end flush against a side wall.
•
The merchandiser should be located at least one inch away from the back wall.
•
There should be enough room in front of the merchandiser for the door to move freely.
Now that you have placed your merchandiser near its permanent location, you need to set up
some of the special options you may have............... Go on to the next page and continue with
the snack section set up.
Snack Section Set-Up
Placing Trays in the Loading Position
WARNING
The bottom tray will rest on the delivery pan assembly. Take care
to avoid striking your fingers against the delivery pan assembly.
1.
Lift up the front of the tray, so that the stop built into the tray clears the roller, then pull
the tray forward and let it return to horizontal position.
2.
Continue pulling the tray forward, then when you are able, tilt the tray downward into the
loading position as shown below.
Summary of Contents for Merchant Six 180
