Merchant™ Operators’ Guide
Initial Setup
1810025
15
August 2009
Removing a Bottle Tray
CAUTION
Be careful to not damage the tray harnesses
when removing trays from the merchandiser.
1.
Remove all product from the tray.
2.
Push down on the left and right front tray latches with your thumbs and slide out the tray as far
as it will go.
3.
Unplug the tray harnesses from the PCB mounted inside the slide-out monetary.
4.
Pull the harnesses through the cabinet.
5.
Locate a small lever on each side of the tray, where it attaches to the slide. The left lever will be
up, the right will be down. Press down on the left lever and up on the right lever.
6.
Pull the tray towards you, off of the slides.
Installing a Bottle Tray
1.
Push the slides back into the cabinet until they stop.
2.
With the tray held at a 45ºangle (with the back higher than the front), align the lower edge of the
rail on the tray with the lower edge of the rail in the cabinet on both sides.
3.
Slowly raise the shelf to a horizontal position, and push the shelf all the way back into the cabi-
net.
4.
Push down on the left and right hand front tray latches with your thumbs and slide the tray for-
ward against the intermediate stop to test that the tray is correctly engaged.
5.
Re-route the harnesses through the cabinet.
6.
Plug the tray harnesses into the PCB mounted inside the slide-out monetary.
NOTE
It is much easier to replace a bottle tray if you have assistance lining up the
tray rails and slides
.
Summary of Contents for Merchant Six 180
