G-13.mft standard/Casino/SGI/BDTA/AMU
F
UNCTION
19
National Rejectors, Inc. GmbH, Buxtehude
Since in most cases the manufacturer’s customer-specific programming
does not take up all the coin channels, channels which are still vacant can
be assigned coin types and further information desired at any time using the
configuration software. Existing configurations can be changed.
The last eight coin channels 25 to 32 (or 9 to 16 with double block data-
management, see section "Single or double block data-management" in this
chapter) are intended to be used for the teach mode. In these coin channels
new coin types can also be taught without configuration software, directly via
the switching blocks on the coin validator; i.e. a coin channel is assigned a
coin type or also a token (see section "Teach mode" in this chapter).
Single or double block data-management
At the manufacturer’s company, a customer-specific setting is programmed
to determine whether the 32 coin channels are to be data-managed in one
memory block or, when divided into 16 channels each, in two memory
blocks (double block data-management).
If the double block data-management has been configured, the G-13.mft can
data-manage two separately programmed (memory) blocks 0 and 1 (see
label). The 16 coin channels can be assigned to each block with different
coin types (also currencies), sorting information, etc. However, only one
block can be active at a time and be used for the coin measurement and for
further coin processing. You can use the upper switching block on the device
to select the desired block (see section "Selecting memory block" in Chap. 6
"Operation").
Summary of Contents for NRI G-13.mft Standard
Page 2: ......
