G-13.mft standard/Casino/SGI/BDTA/AMU
S
TART
-
UP
31
National Rejectors, Inc. GmbH, Buxtehude
1
3
2
4
5
7
6
Fig. 5b: Mounting G-13.mft, front entry model,
to NRI sorting device
8
... on the front entry model
1
If necessary, fasten holding plate 1 with two screws 2 and 3 to
sorting device 4 (see Fig. 5b).
2
Remove screw 5 from coin validator.
3
Use the holding plate to insert the sorting device from the right-hand
side onto the coin validator.
4
Fasten the sorting device with screw 5 to the coin validator.
5
Use the 3-pole sorting plug 6 on the PCB 7 and on the rear of the
coin validator to connect the sorting device to the G-13.mft with the
help of the appropriate sorting cable.
6
Use the 10-pole connection plug 8 on the PCB 7 and on the rear of
the coin validator to connect the sorting device to the G-13.mft for
power supply of the sorting solenoids with the help of the appropriate
connecting cable.
7
Use the 10-pole connection plug 8 on the PCB 7 and the same
connecting cable to connect the coin validator to the machine (see
also section "Installing coin validator to the machine" in this chapter).
Summary of Contents for NRI G-13.mft Standard
Page 2: ......
