M
AINTENANCE
AND
SERVICE
G-13.mft standard/Casino/SGI/BDTA/AMU
42
National Rejectors, Inc. GmbH, Buxtehude
7
Maintenance and service
In this chapter you will find out how to
•
clean the G-13.mft and
•
remedy the cause of a malfunction.
Cleaning coin validator
The coin validator must only be wiped clean from time to time with a damp
cloth (lukewarm water with some detergent). Beyond that, no further
maintenance work is required.
Under no circumstances may the cloth be so wet that fluid
runs into the device. Otherwise the PCB will be damaged.
Do not use any solvents or scouring agents that will attack the
plastic material of the device.
1
Pull the machine’s mains plug.
2
Carefully open the flight deck 1 on the left-hand side and hold it open
(see Fig. 6).
3
Use a cloth to wipe off the coin runway inside the coin validator.
4
Close the flight deck again.
5
Reconnect the machine to the mains supply.
Fig. 6: Opening the flight deck of the validator
1
Summary of Contents for NRI G-13.mft Standard
Page 2: ......
