Note:
1.
Tighten the four screws on
the top, then tight the side screws.
2.
Facing your top-side Y-axis
passive block, you can adjust it to
adjust the timing belt tightness
.
Front
Frame Assembly Pt. 2
8pcs
M5X25
Ready:
Top Frame
Step 1.
Make sure the front of the bottom frame is facing you .
Step 2.
1) Place the Top frame on top of all four aluminum frames.
2) Line up the pre-drilled screw holes on tops of aluminum frame with the holes on top of Top frame and tighten in place with an M5x25
screw and washer at each corner.
3) After 4 screws on top are tightened, use 4 M5x25 screws and washers to fasten corner brackets in each corner of Top frames, into
corresponding holes on outside edge of aluminum frame
4
Summary of Contents for Ender-5 Plus
Page 17: ...14 Circuit Wiring ...