10
ENGLISH
CONNECT THE LP GAS CYLINDER
To connect the gas cylinder:
1. The cylinder valve should be in the OFF position.
2. Make sure the oven control knob is in the OFF position.
3. Inspect the valve connections, port, and regulator assembly. Remove dirt and inspect hose
for damage.
4. When connecting the regulator assembly to the cylinder valve, use your hand to tighten
the nut clockwise until it stops. Using a wrench could damage the quick coupling nut and
cause a hazardous situation.
5. Fully open the cylinder valve by turning the regulator counterclockwise.
6. Before turning on the oven, use a soap and water solution to check any of the connections
for leaks.
7. If a leak is found, close the cylinder valve and do not use the oven until your local supplier
can make repairs.
DISCONNECT THE LP GAS CYLINDER
1. Turn off the oven and make sure the oven is cool.
2. Close the cylinder valve by turning the regulator clockwise until it stops.
3. Detach the regulator from the cylinder valve by turning the quick coupling nut counter
-
clockwise.
4. Put a dust protection cap on the cylinder valve outlet whenever you are not using it.
LEAK TEST
Although the gas connections of the appliance are tested for tightness before packing and
shipping, a full test must be carried out at the installation site.
Before each use, check the tightness of all gas connections by following the procedure be-
low. If you smell gas at any time, you should stop using the appliance immediately and check
the entire system for leaks.
BEFORE THE TESTS
Make sure you have removed all packing material from the appliance.
Prepare a solution of one part liquid detergent and one part water. You will need a spray
bottle, brush, or rag to apply the solution to the components.
Summary of Contents for PRO 97911-192454
