11
ENGLISH
HOW TO PERFORM A LEAK TEST
1. Turn off the oven and open the cylinder valve by turning the regulator counterclockwise.
2. Apply the soap solution to all gas connections. Soap bubbles will appear where there is a
leak.
3. If there is a leak, immediately shut off the gas supply and tighten any leaking connections.
4. Turn the gas back on and check again.
5. If the gas leak persists at any of the connections, turn off the gas supply and contact
customer service.
USE THE OVEN
Each burner has a nominal power of 4.0KW. To get started:
1. Remove all packing material.
2. Make sure the oven has undergone a leak test and is properly seated.
3. Light the burner by following the lighting instructions below.
INSTRUCTIONS FOR USE
LIGHTING USING THE BURNER VALVE
1. Make sure the control knob is in the OFF position and open the cylin
-
der valve by slowly turning the regulator counterclockwise.
2. Push and slowly turn the oven control knob counterclockwise until
you hear a click and the burner ignites.
3. If the burner does not light, turn the knob to the OFF position, wait
5 minutes and repeat the lighting process.
LIGHTING INSTRUCTIONS
LIGHTING USING A MATCH
1. If after several attempts to light the oven with the control knob the
burner does not light, it can also be lit with a match.
2. If you have already tried unsuccessfully to light the burner with the
control knob, wait 5 minutes for the gas to dissipate.
3. Place a match in the match holder, light it and feed it through the
oven opening to the burner.
4. Push and slowly turn the control knob to HI, and the burner should
light immediately.
5. If the burner does not light within a few seconds, turn the control
knob to the OFF position, wait 5 minutes, and try again.
Summary of Contents for PRO 97911-192454
