ENGLISH
10
Lo c k i n g
pin
MOUNT AND HANG THE FAN
Electrical
wiring
Floron
Ball coupling
Embellisher
Screw
Adapter
Fixing screw
Locking
pin
• If you want to extend the suspension length of your fan, you must remove the hanging ball
from the rod provided for use with the extension rod (included).
(If you want to use the downrod, follow the instructions below.)
• To remove the hanging ball, loosen the hanging ball set screw and remove the pin and
bolt. Lower the hanging ball and remove the stopper pin. Slide the hanging ball out of the
original rod and slide it down the longest rod (it should be noted that the top of the rod has
a hole for the set screw, use this hole when inserting the set screw).
• Insert the stopper pin into the top of the extended rod and lift off the hanging ball.
• Make sure the stopper pin aligns with the slots on the inside of the hanging ball, securely
tighten the set screw.
Tip
: To make it easier to feed the wires into the bar, wrap some electrical tape around the
wires. This will help you hold them together as you insert them into the bar.
• Loosen set screws and washer on top of motor housing. Remove the pins from the bar (if
you haven't already). Insert the rosette through the bar.
• Pass the cables through the bar and pull the excess cables from the top of the bar to tight-
en them.
• Place the bar inside the motor housing and insert the pins you removed earlier. Tighten the
set screws and washers.
• Lower the rosette onto the motor housing.
Summary of Contents for Wind Easy
