7
ENGLISH
• To avoid personal injury and damage,
make sure the location to hang the
blades allows clearance of 2.3 m
from the ground and 76 cm from any
wall or obstruction.
• Make sure the outlet box is securely
attached to the building structure
and can support the full weight of the
fan.
INSTALLATION PREPARATION
76 cm of
separation
between
the wall or
obstacle.
2.3 m from the
blades to the
ground
• To avoid possible electrical shock, before installing your fan, disconnect power by turning
off the circuit breakers at the outlet box and the associated wall switch location. If they
cannot lock the circuit breakers in the off position, securely attach a prominent warning
device, such as a tag, to the service panel.
• All wiring used must be in accordance with national and local electrical codes and ANSI /
NFPA 70. If you are not familiar with wiring, contact a qualified electrician.
• To reduce the risk of personal injury, do not bend the blade support system when installing,
balancing, or cleaning the fan.
• Never insert foreign objects between the rotating fan blades.
•
To reduce the risk of fire, electrical shock, or motor damage, do not use solid-state speed
control with this fan. Use only original speed controls.
• This appliance can be used by children aged from 8 years and above and persons with
reduced physical, sensory or mental capabilities or lack of experience and knowledge if
they have been given supervision or instruction concerning use of the appliance in a safe
way and understand the hazards involved.
• Children must not play with the appliance.
• Cleaning and maintenance of the appliance should not be carried out by children, unless
they are over 8 years of age and supervised.
• Close supervision is necessary when any appliance is used by or near children.
TIP
: Important precautions and safety instructions appearing in the manual are not intended
to cover all possible conditions and situations that may occur. It should be understood that
common sense and caution are necessary factors in the installation and operation of this fan.
•
Mark the correct position of the holes and fix the ceiling support using the screws with
metal plugs or screws and washers appropriate to the type of ceiling chosen.
• Check the correct installation of the bracket before hanging the fan. This plate must
support the entire weight of the fan.
•
Do not fix the mounting bracket directly on ceilings with thickness less than 10mm to avoid
the risk of the screw loosening.
INSTALLATION INSTRUCTIONS
