Assembly
MODEL PS10FRA
19766-100 Rev B (05-10)
© Copyright 2010, Creative Playthings. Printed in U.S.A.
3DJH
ASSEMBLY INSTRUCTIONS
67(3²$VVHPEOH$FFHVV/DGGHU
Slide a Rung Collar (N) over each end of all 18" Rungs (L).
Press each 18" Rung Assembly into the holes in the Right
Access Ladder Rail (H) until the Rung Collar is tight against
the Rail. Position the other Left Access Ladder Rail (G) so
WKH5XQJ$VVHPEOLHVÀWLQWRWKHKROHV,IWKHÀWLVWRRWLJKWWR
assemble by hand, use a hammer, padded with the Assem-
bly Block (K), to force the Rails onto the Rung Assemblies.
Use one #10 x 2-1/2" Self-drilling Screw to secure each end
of each Rung. Make sure that the collar of each Rung As-
sembly is tight against the Rails before inserting the screws
LQWRWKHKROHVDQGIDVWHQLQJWKHPZLWKDGULOOÀWWHGZLWKD
Phillips bit.
:KHQIDVWHQLQJSUHVVÀUPO\ZLWK\RXUERG\PDVVFHQWHUHG
over the drill.
STEP 20 – Bottom Rope Support and Slat:
Fasten the Bottom Rope Ladder Support (B) to the Access
Ladder Assembly using two 1/4" x 4-1/2" Hex Bolt Assem-
blies as shown.
Fasten the Ladder Slat (S1) to the Access Ladder Rails us-
ing four #10 x 1-1/2" Screws. The gap between the Ladder
Slat and the top Rung should be 3-1/4".
STEP 21 – Fasten Access Ladder to Gym:
Loosely fasten two Access Ladder Brackets to the Access
Ladder Rails using one 5/16" x 1-1/2" Hex Bolt Assembly
each, as shown.
Position the Access Ladder Assembly against the Right Plat-
form Side.
Fasten the Access Ladder Brackets to the Right Platform
Side using 5/16 x 1-1/2" Hex Bolt Assemblies, as shown.
Tighten all hardware.
G
N
L
K
H
S1
B
3-1/4"
