© Copyright 2010, Creative Playthings
MODEL PS10LIN
19764-100 Rev D (05-10)
Page 14
ASSEMBLY INSTRUCTIONS
67(3²6DIHW\5DLO
Fasten the Safety Rail (V) to the left Corner Posts using one
5/16 x 3" Lag Screw and one 5/16" Flat Washer for each
end. Use the pre-drilled pilot holes.
STEP 17 – Assemble Access Ladder:
Slide the Plastic Steps (AK) into the slots cut into the Left
DQG5LJKW6WHS6XSSRUWV' (DVVKRZQ0DNHVXUHWKH
WDEVRQWKHVLGHVRIWKHVWHSVÀWWLJKWO\DJDLQVWWKHIDFHRI
the Step Supports. Secure each Plastic Step using four #8 x
2-1/2" Screws through the holes provided.
Fasten The Ladder Slat (B) to the back of the Step Supports
using four #10 x 1-1/2" Screws. Leave a gap of 3" between
the top of the Step and the bottom of the Ladder Slat.
STEP 18 – Install Access Ladder:
Loosely fasten the Access Ladder Brackets to the Access
Ladder Assembly using one 5/16" x 1-1/2" Hex Bolt Assembly
each, as shown.
Position the Access Ladder Assembly against the Platform
Front.
Fasten the Access Ladder Brackets to the Platform Front
using 5/16 x 1" Hex Bolt Assemblies, as shown. Tighten all
hardware.
V
E
D
AK
B
3" Gap
