About the Sound Blaster Audigy Card and external Audigy Drive 1-6
Using Creative
Surround Mixer
To adjust headphones volume:
1. Click
Start
->
Programs
->
Creative
->
Sound Blaster Audigy
->
Surround
Mixer
.
2. On the lower half of Surround Mixer, make sure that the
Mute
check box under
the
Volume
slider is clear. Otherwise, click the check box.
3. Drag the
Volume
slider left or right to adjust the headphones volume.
To adjust microphone gain:
1. Click
Start
->
Programs
->
Creative
->
Sound Blaster Audigy
->
Surround
Mixer
.
2. On the lower half of Surround Mixer, click an audio input source button with a
down arrow, and then select
Line-In 2/Mic 2
.
3. Make sure the check box below the
Line-In 2/Mic 2
slider is cleared. If not, click
it to clear the check box. This will unmute the audio input source.
4. Drag the slider to adjust the microphone gain.
Using a Remote
Control with
Your Computer
The external Audigy Drive has an infrared receiver for the remote control. This
remote control lets you operate your computer from the comfort of your sofa or bed
up to a distance of 4 meters. For details, refer to the RemoteCenter
To install Surround Mixer and
other applications, see
• For best effects, set the
headphones volume and
microphone gain levels to
75% in Surround Mixer,
and then use the external
Audigy Drive’s control
knobs to make further
adjustments.
• If you set the headphones
volume or microphone
gain levels to 0%, or mute
them in Surround Mixer,
you hear no sound if the
external Audigy Drive’s
control knobs are set to
the maximum.
