Cutter’s Mate
Owner’s Manual
11 van 14
Cuttersmate-europe 2012 Rev. 1
Adjusting the Cutting Angle
To maintain a 90-degree angle to the surface of the glass, your Cutter’s Mate may need to be adjusted
slightly. This is accomplished by raising or lowering the threaded shaft collars on the slide cylinder.
Loosen the screws in the threaded shaft collars. Turn the threaded collars to adjust the arm up or down the
desired amount. Re-tighten the screws, being careful not to over tighten.
NOTE:
Care should be taken when adjusting the threaded collars. If they are too tight against the arm disk,
movement may be restricted. Leaving them too loose may cause the arm to have too much play
.
