Before Fitting:
Before connecting to the electricity supply
leave the appliance to stand for 2 hours to
allow the cooling system to settle.
Please read through this section before
starting any work.
At the base of the kitchen unit intended for
installing the appliance, there should be at
least 200cm
2
free space, for adequate air
circulation.
Do not cover the air outlet grille at the top of
the appliance.
Your Integrated Fridge Freezer is designed to
fit into a tall housing as shown (fig 1). It is
vitally important that the appliance is vented
correctly.
Choosing a location:
Your Integrated Fridge Freezer should be
fitted into a kitchen unit space where it is easy
to use.
The power socket should be in a readily
accessible position adjacent to the unit.
Never place the appliance near a heat
emitting device (eg. cooker, radiator, water
heater or similar) and do not expose it to
direct sunlight. In such a position your Fridge
Freezer will have to work harder and will cost
more to run and may be damaged by the
heat. The appliance may be exposed to lower
or higher temperatures but only for short
periods of time and the temperature should
never be lower than 5˚C.
The rear wall of the appliance gets warm
during operation and water evaporates from
the drain pan on the compressor. You must
therefore provide adequate air circulation at
the rear of the appliance.
Installation.
WARNING: THE APPLIANCE SHOULD
ONLY BE INSTALLED BY A QUALIFIED
ELECTRICIAN IN COMPLIANCE WITH THESE
INSTRUCTIONS, CURRENT STANDARDS
AND REGULATIONS.
4
Fig. 1
A (mm)
B (mm)
C (mm)
Bottom door
Top door
Cabinet
846
840
1775-1780
Plinth Ventilation
545
545
694527.qxd 1/31/03 9:18 Page 4
