2
If you have a modem only:
1.
Unplug the power cord on your modem.
2.
Place your AIRAVE in a central location close to a window. An elevated location, such as the top of a bookshelf
or tall cabinet, works best.
3.
Connect the external GPS antenna to the AIRAVE and place the antenna on a flat surface as close to a window
as possible.
4.
Connect one end of the included yellow Ethernet cable to your AIRAVE’s yellow WAN port.
5.
Connect the other end of the yellow Ethernet cable to the open Internet/Ethernet/LAN port on your modem
Please note:
Any devices you’d normally plug into the modem, such as your computer, should be connected to
one of the AIRAVE’s LAN ports.
6.
Plug your modem back in and turn it on.
Important:
Wait about two minutes for the modem to start up before continuing.
7.
Plug the power supply connector into the black power port on your AIRAVE.
Please note:
To prevent damage to your AIRAVE, do not plug the power cord into an electrical outlet yet.
8.
Connect the power cord into the power supply and then plug it into an available outlet.
To internet
Modem
GPS
PHONE
LAN1
LAN2
WAN
External GPS antenna
AIRAVE
PC
Power supply
9.
The AIRAVE will turn on and go through an automated setup sequence that may take up to two hours. During
this time, the LEDs will change color.
10.
Once the Broadband, GPS and Mobile LEDs are
solid
green, your AIRAVE is ready to use. Your phone(s) will
automatically connect to the AIRAVE when in range.
Please note:
When you’re connected to the AIRAVE, you’ll hear three short beeps at the start of each call. You may
not hear the beeps the first few times after your AIRAVE is activated.
