3 of 4
LPN00238X0001A1_E
STEP 2:
Mount the luminaire base to mounting
surface using one of the following
methods:
A - Surface Mounting
Secure luminaire base to mounting
surface by inserting (2) customer
supplied #8 anchor screws,
toggle bolts or suitable fasteners,
depending on structural conditions,
into key hole slots on the top side of
the luminaire base. See
Figure 3
.
B - Pendant Mounting
Attach luminaire base to (2)
customer supplied 1/2" diameter
pendant using the pendant holes on
the top side of the luminaire base
shown in
Figure 3.
B - Aircraft Cable Mounting
Attach (2) customer supplied aircraft
cable to the designated opening on
the top side of the luminaire base as
shown in
Figure 3.
NOTE:
8’ luminaires will have
C - T-Bar Ceiling Grid Mounting With
T-Bar Clips
Attach (2) customer supplied T-Bar
clips to the designated opening on
the luminaire as shown in
Figure 3.
Bring luminaire into T-Bar ceiling
grid and secure luminaire to grid.
NOTE:
8’ luminaires will have (4)
designated openings for customer
supplied T-Bar clips.
D - Chain Mounting
Attach (2) customer supplied
V-hooks to each end of the luminaire
base. Attach customer supplied
chain to the V-hooks and mounting
surface. See
Figure 3.
STEP 3:
For single luminaire installation
proceed to the next Step.
For multiple luminaire installation,
insert customer supplied chase nipple
and lock nuts into the knockout on the
end cap located on each end of the
luminaire. See
Figure 5.
B
A
C
D
D
E
D
D
B
A
C
E
E
A -
Keyhole Slots for Surface Mounting
B -
(1/2") Pendant Mounting Hole or Aircraft Cable
C -
T-Bar Clip Mounting Hole
D -
V-Hook Openings for Chain Mounting
E -
Wiring Knockouts
E
3
End Cap
End Cap Wiring
Knockouts
Dimming Wire
Compartment
4
5
Customer Supplied Chase
Nipples and Lock-nuts
Emergency Driver
