ODC 1220™
O
OU
UT
TD
DO
OO
OR
R D
DIIS
SC
CO
OV
VE
ER
RY
Y C
CR
RA
AF
FT
T
T
TM
M
Warning:
Please read and follow carefully.
1. Always wear a US Coast Guard approved personal flotation device when in your ODC 1220.
2. Never float alone.
3. Always check your ODC 1220 air bladders, frame, oar components, and pontoon covers for possible damage
before you use your craft.
4. Never use your craft if you suspect the air bladders, frame, oar components, or pontoon covers has been damaged.
5. Never over inflate your ODC 1220.
6. Never use your ODC 1220 without the air chambers fully inflated.
CARE AND MAINTENANCE:
1. If your pontoon bladder is losing air, please check that valve assembly and top valve cap are fully seated. Reseat valve
assembly and repeat pontoon inflation instructions.
2. Do not store your ODC1220 in direct sunlight.
3. If you are leaving your ODC 1220 out in the sun for any amount of time, be aware that the heat can increase the
pressure inside the pontoons to a dangerous level. Let some of the air out of the pontoons if the craft will be out of the water
in the sun for any length of time, or if it is stored in a vehicle, etc.
4. A gain in altitude will increase the pressure in the pontoons also. If you are taking your inflated ODC 1220 from
a low elevation to a high elevation, be sure to let some of the air out of it.
5. For short term storage, we recommend you let some air out of your pontoons.
6. For long term storage, we recommend you make sure your ODC 1220 is completely dry, deflated and stored out of
the sunlight in a cool dry area.
7. Repairing bladder, use enclosed patch kit. Fully deflate bladder. Remove safety split-ring from zipper pull and open
zipper in pontoon cover. Remove bladder from inner liner. Identify puncture. Clean and dry area around puncture.
Apply glue to puncture area and patch using applicator straw. Press patch over puncture area. Allow 24 hours to
dry before Inflation.
8. Note: Metal parts may rust and are not covered under warranty.
Your ODC Outdoor Discovery Craft is designed to give you many years of service.
Please follow inflation instructions and warnings carefully.
IF YOU EVER HAVE ANY
QUESTIONS OR PROBLEMS WITH YOUR ODC 1220 PLEASE DO NOT
RETURN IT TO THE DEALER YOU BOUGHT IT FROM. PLEASE CONTACT THE CREEK COMPANY
WE ARE
OPEN M-F 9AM-5PM MOUNTAIN TIME. OR CONTACT US
VIA
AT INFO@CREEKCOMPANY.COM.
HIN
IS LOCATED ON SQUARE TUBING OF SEAT SUPPORT FRAME MEMBER
AND ON RIGHT MAIN FRAME MEMBER (SEE FIGURE 4)
Accessories are available for your ODC 1220. Ask for them where you bought your ODC 1220,
or visit the Creek Company Store at www.creekcompany.com
The Creek Company Ltd. , PO Box 773892, Steamboat Springs, CO 80477
email: info@creekcompany.com
Specifications and other details subject to change without notice.
All Creek Company products are guaranteed against defects in material and workmanship for the life of the product to
the original owner. This does not cover damage due to misuse or normal wear and tear.
