ODC 816™
O
OU
UT
TD
DO
OO
OR
R D
DIIS
SC
CO
OV
VE
ER
RY
Y C
CR
RA
AF
FT
T
Your ODC Outdoor Discovery Craft is designed to give you many years of service.
Please follow inflation instructions and warnings carefully.
IF YOU EVER HAVE ANY QUESTIONS OR PROBLEMS WITH YOUR ODC 816 PLEASE DO NOT
RETURN IT TO THE DEALER YOU BOUGHT IT FROM. PLEASE CONTACT THE CREEK COMPANY
DIRECTLY TOLL FREE AT 1-800-843-8454. WE ARE OPEN M-F 9AM-5PM MOUNTAIN TIME. OR CONTACT US VIA
E-MAIL AT INFO@CREEKCOMPANY.COM.
HIN
(HULL IDENTIFICATION NUMBER) IS LOCATED ON SQUARE TUBING OF SEAT SUPPORT FRAME MEMBER
AND ON RIGHT RIGHT SIDE CARGO DECK (SEE FIGURE 1)
Warning:
Please read and follow carefully.
1.
Always wear a US Coast Guard approved personal flotation device when in your ODC 816
.
2.
Never float alone.
3.
Always check your ODC 816
Air Bladders, Frame, Oar Components and Pontoons Covers for possible damage before you
use your craft.
4.
Never use your craft if you suspect the Air Bladders, Frame, Oar Components and Pontoons Covers has been damaged.
5.
Never overinflate your ODC 816
.
6.
Never use you ODC 816
without the Air Bladders fully inflated.
CARE AND MAINTENANCE:
1.
If your Air Bladder is losing air, please check that valve assembly and top valve cap are fully seated. Reseat valve
assembly and repeat pontoon inflation instructions.
2.
Do not store your ODC 816
in direct sunlight.
3.
If you are leaving you ODC 816
out in the sun for any amount of time, be aware that the heat can increase the pressure
inside the pontoons to a dangerous level. Let some of the air out of the Pontoons if the craft will be out of the water in the sun
for any length of time, or if it is stored in a vehicle, etc.
4.
A gain in altitude will increase the pressure in the Pontoons also. If you are taking your inflated ODC 816
from a low elevation
to a high elevation, be sure to let some of the air out of it.
5.
For short term storage, we recommend you let some air out of your Pontoons.
6.
For long term storage, we recommend you make sure your ODC 816
is completely dry, deflated and stored out of the sunlight
in a cool dry area.Do not store your wet ODC 1018
™
in freezing temperatures as this may result in frame and
other component damage.
7
. Repairing bladder, use enclosed patch kit. Identify puncture. Fully deflate bladder.
clean and dry area around puncture. Apply glue to puncture area and patch using
applicator straw Press patch over puncture area. Allow 24 hours to dry, before inflating.
8.
Note: Metal parts may rust and are not covered under warranty.
9
. We recommend the use of electric trolling motors only on your ODC 816
™
.
10
. Do not use the cargo deck as a standing platform. It is not designed for this and may break
if used in this capacity.
Accessories are available for your ODC 816
. Ask for them where you bought your ODC 816
,
or visit the Creek Company Store at www.CreekCompany.com
The Creek Company Ltd. , PO Box 773892, Steamboat Springs, CO 80477
970-879-5221 • fax 970-879-7577 • email: info@creekcompany.com
Specifications and other details subject to change without notice.
All Creek Company products are guaranteed against defects in material and workmanship for the life of the product to
the original owner. This does not cover damage due to misuse or normal wear and tear.
Made in China
™
