ODC XR 12
O
OU
UT
TD
DO
OO
OR
R D
DIIS
SC
CO
OV
VE
ER
RY
Y C
CR
RA
AF
FT
T
ASSEMBLY INSTRUCTIONS
I. PADDED SEAT ASSEMBLY
1. Assemble Seat Back to Seat Bottom using Seat Assembly Pins (see figure 1a). Assemble both seats at this time.
II. FRAME ASSEMBLY
NOTE: Your frame assembles using (22) Short Snap Pins and (4) Long Snap Pins. Please follow instructions accordingly.
A. ASSEMBLE FRONT FISHING FRAME USING THE FOLLOWING STEPS:
1. Assemble Seat to Tall Seat Support Frame Member using (4) Seat Screws.
(see figure 1b).
2. Assemble Seat Support Frame Member to Left and Right Frame Members using (4) of the Short Snap Pins. (see figure 1).
3. Assemble Tall Seat Support Frame Member to Seat Support Frame Member using (4) Short Pins. (see figure 1b).
4. Assemble Leaning Bar to Left and Right Frame Member. Do not insert (2) Short Snap Pins until following step 7 (see figure 1).
5. Assemble Standing Platform to Left and Right Frame Members using (4) Long Snap Pins. ( 2 ) of these pins also pin
together Leaning Bar and finish step 6. (see figure 1)
6. Assemble Long U-Bar to back of Left and Right Frame Member using (2) Short Snap Pins. (see figure1)
B. ASSEMBLE REAR ROWING FRAME USING THE FOLLOWING STEPS:
1. Assemble Seat to Seat Support Frame Member using (4) Seat Screws.(see figure 1a)
2. Assemble Seat Support Frame Member with Underseat Lift and Lock Anchor System attached
to Left and Right Frame Members using (4) Short Snap Pins (see figure 2).
3. Assemble Short U-Bar to back of Left and Right Frame Member using (2) Short Snap Pins (see figure 2).
4. Assemble Cargo Deck to back of Left and Right Frame Member using (2) Short Snap Pins (see figure 2).
5. Assemble Foot Brace to front of Left and Right Frame Member. Foot Brace can be assembled in longer position or shorter
position using (2) Short Snap Pins (see figure 2).
6. Attach Anchor Line Storage Bag to Seat Support Frame Member (see figure 1a).
7. See figure 5 and 6 for use of Underseat Lift and Lock Anchor System.
C. CONNECTING FRONT FISHING FRAME TO REAR ROWING FRAME.
Attach back of Front Fishing
Frame Left and Right Frame Member to Foot Brace of Rear Rowing Frame using (2) Short Snap Pins (see figure 4).
III. PONTOON INFLATION
NOTE: Use the large cone adapter provided with your pump. See figure 3a for a detail of the valve assembly. Before
inflation, be sure to fully seat each valve assembly into the pontoon, screwing tightly by hand. When fully seating valve
assembly, be sure that the valve plate is in place around valve assembly and not restricting the valve assembly from a full
seal. After inflating, be sure to fully seat the top cap on to each valve assembly, screwing tightly by hand. Both are
required for an airtight seal.
1. Inflate each pontoon. The valve is located under the valve cover at the top and center of each Pontoon (see figure 3).
Inflate until firm (do not over inflate).
2. Again, be sure top valve cap and valve assembly are fully seated to achieve airtight seal.
PONTOON DEFLATION: Unscrew entire valve assembly from pontoon.
T
TM
M
T
TM
M
