IV. ATTACH PONTOONS TO FRAME
NOTE: Always inflate the Pontoons first, before attaching to frame.
1. Position inflated Pontoons under the Left and Right Frame Members with ODC XR 12 logo oriented to the outside.
The valve covers at top of Pontoon should fit between the Front Fishing Frame and the Rear Rowing Frame (see figure 3).
2. Attach each Pontoon to frame using (8) Cam Lock Straps. Slip each strap through D-Ring on Pontoon, around frame and pull
tight through Cam Lock Buckle. NOTE: Be sure the straps are pulled tight through the Cam Lock Buckles (see figure 3).
IIIa. ONE MAN CONVERSION:
Your ODC XR 12 can be converted to a one man craft by centering the Rear Rowing
Frame only on the Pontoons, leaving the Front Fishing Frame detached.
V. OAR & OARLOCK ASSEMBLY
1. Slide the Oar Stop over the handle end of the Oar Shaft.
2. Assemble 2 oar shaft pieces and blades.
3. Place Oarlock Bushing over Oarlock shaft and place Oarlock into frame. Frame has 3 Oarlock postions for a custom fit. Attach
split ring at end of Oarlock shaft to secure Oarlock in place. (see figure 7)
4. With Oarlocks installed on the Frame, slide Oars into Oarlocks starting at blade end of Oar. The Oars should be
adjusted equally left and right allowing at least two thumbs distance between the Oars to avoid pinching your thumbs when rowing.
Tighten the Oar Stops in place.
Figure 1
Front Fishing Frame
Assembly
A. Standing Platform
B. Leaning Bar
C. Right Frame Member
D. Left Frame Member
E Seat Support Frame Member
F. Long U-Bar
B
C
D
E
F
A
Detail Of
Snap Pin
Installation
FRONT FISHING FRAME
Figure 5
Underneath
View of
Underseat Lift
and Lock
Anchor System
To Front of Boat
Left Pontoon
Right Pontoon
to Anchor
(not Included)
Cargo
Deck
Anchor Rope
(not Included)
Anchor Line
Pulley
Designed to be
used while
sitting in rowers
seat.
To Back of Boat
Underneath View of Boat
Figure 4
Connecting
Frames
