Loading Film
41
2.
To direct the exposed film to the unloading/accumulating cassette,
turn the selector to the left (counter-clockwise).
Or,
To direct the exposed film to the inline processor, turn the selector to
the right (clockwise).
Loading Film
When the loading cassette runs out of film, the control panel prompts end
of film, and the loading drawer opens.
The loading film procedure consists of the following stages:
•
Removing the loading cassette from its drawer
•
Loading a roll of film into the loading cassette
•
Placing the loaded cassette in its drawer
•
Trimming the film.
Removing the Loading Cassette from its Drawer
To remove the loading cassette from its drawer:
1.
Pull the film loading drawer to open it to its full extent.
2.
Grasp the loading cassette by the inset handles on both sides.
3.
Lift the cassette, and remove it from the drawer.
Note:
The film path selector determines whether the exposed film
is output to the film unloading cassette or to the inline processor. Since the
selector is arrow-shaped, it points to the selected output device (that is, to the
film unloading cassette or to the inline processor).
Warning:
To avoid hurting your knuckles, keep your fingers straight.
Summary of Contents for Dolev 4press V
