54
Chapter 2 – Handling Cassettes and Media
The default (61 m) specifies that the loaded film is a full roll.
If you did not load a full roll of film, toggle this field to its current length
(in meters).
Exposing
After you press the
Done
soft button on the Media Info window,
FIRST LOAD and ATTACH are performed (see Chapter 4, Calibration and
Service Utilities, Service Utilities Mode on page 75).
STANDBY appears on the control panel. (If it does not, see Chapter 1,
Introduction to the Imagesetter, Control Panel Status on page 33).
Now is the time to send the file you want to expose from the host to the
imagesetter.
After communication between the imagesetter and the host has been
established, the control panel prompts:
The imagesetter starts to expose, and the following icon appears on the
control panel:
The Progress indicator on the control panel shows how much exposing has
been completed.
During exposure, you may view the system messages (see Chapter 1,
Introduction to the Imagesetter, Control Panel Status on page 33), or the
exposure parameters (see Chapter 2, Handling Cassettes and Media, Control
Panel Functionality on page 55).
Note:
If the required value falls between suggested options, select a higher
value.
Summary of Contents for Dolev 4press V
