40
Chapter 3 – Media Management
3.
To unload the
large
(34 inch) cassette
[1]
, open the Large cassette door
[2]
(located on the front on the imagesetter) and then open the
additional
inner
door
[3]
.
Figure 13: Unloading the Large Cassette
4.
Remove the cassette and take it to the darkroom.
Mounting Media onto the Supply Cassette
1.
Check that the film you intend to load on the cassette is in the
darkroom before you lock the door and turn
off
the lights.
2.
Close and lock the door to the darkroom.
3.
Turn
on
the bright cyan light.
4.
Two latches secure the cassette lid. To open the supply cassette, push
the latches horizontally toward the center of the cassette, and pull up
the lid until it is in a resting position.
CAUTION:
Dolev 800V+/800V
2
/800V
3
requires a bright cyan light source for
film development. Do not use red or yellow illumination!
Summary of Contents for Dolev 800V+
