Set Loading (Automatic Media Loading)
45
Set Loading (Automatic Media Loading)
The Set Loading procedure assists you during the loading process. During
loading, the section of media exposed to light must be cut.
Set Loading
automatically loads a minimum length of media onto the drum, cuts the
exposed media, and ejects it into the output cassette.
You must then unload and discard the length of film that was exposed to
light. Do this before you begin your first exposure.
Set Loading
may be performed via the Control Panel (as explained on the
following page), or via the host workstation.
Performing Set Loading via the Control Panel
1.
At
STANDBY
, press the <
Util
> soft button.
The
Utilities
menu appears; the pointer cursor points to
Set Loading
.
2.
Press the
Done
soft button.
3.
Press the
Next-Value
soft button to toggle the
SML
in the
Parameter
area to
MED
or
LRG
as desired.
4.
Press the
Done
soft button to confirm the selection of the desired
supply cassette.
5.
When loading is completed successfully, the following appears on the
Control Panel:
PASS
6.
Press the
ESC
soft button to return to the
Utilities
menu, or the
ERROR
soft button to see a list of errors (if such exist).
Note:
To cancel the selection, press the
Esc
operator button.
Summary of Contents for Dolev 800V+
