5925 Heisley Road • Mentor, OH 44060-1833
Holding Cabinet
FL-2361
Rev. 4 (10/13)
Page 3 of 12
INSTRUCTIONS TO INSTALLER BEFORE CONNECTING TO GAS AND ELECTRIC SUPPLIES
1 . Retain this manual for further use .
2 . Post in a prominent place the following instructions:
FOR YOUR SAFETY
IF YOU SMELL GAS:
1. Open windows.
2. Don’t touch electrical switches.
3.
Extinguish any open flame.
4. Immediately remove propane tank,
shut off gas supply or call your gas
supplier.
FOR YOUR SAFETY
Do not store or use gasoline
or other flammable vapors
and liquids in the vicinity of
this or any other appliance.
3 . Installation in the United States must conform with the local codes, or in the absence of local codes, with
the NFPA 54/ANSI Z223 .1 2012 . Installation in Canada must comply with the Installation codes for Gas
Burning Appliances and Equipment, CAN/CSA B149 .1-10 and/or local codes .
4 . The area around cabinet must be kept free and clear from combustible materials .
5 .
DO NOT obstruct the flow of combustion and ventilation air. DO NOT block slots or louvers on front and
rear of unit in any way .
6 . The cabinet when installed must be electrically grounded in accordance with the local codes, or in the
absence of local codes, with the National Electrical Code ANSI/NFPA 70-2011 .
This appliance is equipped with a three-prong (grounding) plug for your
protection. Do not cut or remove the ground prong from this plug.
7 .
Provisions for adequate air supply, in cabinet area, must be provided.
8 .
Adequate clearances for servicing and proper operation must be provided.
9 . DO NOT ATTEMPT TO OPERATE CABINET DURING A POWER FAILURE .
10 . CLEARANCE FROM COMBUSTIBLE CONSTRUCTION, 0 INCHES FROM SIDE AND 0 INCHES
FROM BACK .
11 . Wiring diagrams can be found in operating instructions (page 12)
INSTALLATION INSTRUCTIONS
WARNING