Matrix Mix
features
The Matrix section is fed from the internal Bus 13 thru 16 signals.These internal buses get
their signal from the Input and Groups via the Bus 13-16 assignment switches.The assign-
ment to Buses 13-16 is normally post-fader, a master switch globally changes this to pre-
fader. Each Matrix also has its own External input which can be mixed in with the Bus 13-
16 signals.The External Input signal comes from the four 1/4” TRS jacks located on the rear
of the Master Module.
13-
Bus 13 mix level into the Matrix.
14-
Bus 14 mix level into the Matrix.
15-
Bus 15 mix level into the Matrix.
16-
Bus 16 mix level into the Matrix.
EXT IN-
External Input mix level into the Matrix, from TRS jack on rear panel
MUTE-
Micro-controllable mute control. See Micro-instructions for operation.
LEV-
Master Level control for Matrix output.
SOLO-
Allows monitoring of the Matrix signal in the Solo system.This feed follows
the master SOLO MODE switch. Pre-fader monitors the actual Matrix mix-bus, Post-Fader
monitors the Matrix signal after the Master Level and Mute controls. In the X-Monitor, the
Solo system makes a distinction between Inputs and Outputs.The Matrix Solo is treated as
an Output by the Solo system. See the Solo Section of the manual for details on the differ-
ent Solo functions and modes.
p. 33
Master section
3
