© RESQ RED Pro III
2
This document gives information about the correct use of the
RED Pro III
in different situations. These instructions must be read
and fully understood by all persons who are going to use the
RED Pro III
. We also recommend that all employers must read these
instructions carefully, to ensure a good safety level together with a full understanding of the product and its use. Users shall be
trained in the use of the equipment.
1 I N T R O D U C T I O N
This emergency equipment is designed for evacuation from height, and operates automatically, descending in a bi-directional
format. It can be used for one or two persons descending at the same time with a controlled descent speed of 0,5-2m/s. It is fitted
with an integrated rescue lifting function that can be used to lift one person for short distances, in accordance with the limitations
for load and distances set out under “Technical data” in this user instruction.
User training with the
RED Pro III
should be under supervision of Cresto trained instructors or Instructors authorized by Cresto or
Cresto partners.
This equipment is made in accordance with the European PPE Regulation 2016/425 and complies with EN341:2011 Descender
device class A & class B; rescue lifting device EN1496:2017.
Applicable as evacuation equipment from Wind turbines, tower cranes, sky lifts, buildings, towers etc.
Warning!
The equipment shall only be used by a person trained and competent in a safe use.
Warning!
The user-/s must be in good physical and mental condition. In case of known disorder, the user must be aware of pos-
sible consequences, as conditions such as cardiovascular conditions, diabetes, blood pressure deviations, epilepsy and balance
problems or any other medical condition that can be hazardous to the safety using the equipment.
Warning!
Equipment use must be supported by the company’s own accident emergency procedures related to daily work.
Warning!
Do not make any alternations or additions to the equipment without the manufacturer´s prior written consent, and any
repair shall only be carried out in accordance with the manufacturer´s procedures and guidelines.
Warning!
Do not use the equipment outside its limitations or for no purpose other than that which it is intended.
Warning!
The equipment must only be used for rescue and evacuation and not intended as fall arrest equipment or as a utility
crane.
2 M A R K I N G & I L L U S T R AT I O N S
See figure 1 and figure 2.
1. Manufacturer
2. Compliance
3. Serial number
4. Date of manufacture
5. Weight restrictions
6. Temperature limit
7. User instruction
8. Length
8
3
4
5
1
7
6
2
Figure 1
Summary of Contents for RESQ RED Pro III
