AM/FM/SR Tuner Card
Crestron
Adagio ATC-AMFMSR
6
•
AM/FM/SR Tuner Card: ATC-AMFMSR
Operations & Installation Guide – DOC. 6463A
Setup
This section contains hardware installation and setup instructions for the
ATC-AMFMSR.
Required Tools/Hardware
1. Small flat bladed screwdriver
2. Grounding strap (encouraged)
Installation
CAUTION:
The ATC-AMFMSR and the Adagio Entertainment System contain
electrostatic discharge (ESD) sensitive devices. Crestron
®
encourages you to wear a
grounding strap to avoid damaging the card and/or the host system.
When inserting a card into the Adagio Entertainment System you may need to move
other source connections if designated connectors are occupied by other sources. For
programming purposes, slots and source connections are matched according to the
following table:
Slot 1
Slot 2
Slot 3
Source
Connections
1&2
3&4
Refer to
note below.
CAUTION:
Do not connect external sources to SOURCES connectors used by tuner
cards.
CAUTION:
Be certain to insert tuner card before applying power to the Adagio
Entertainment System
.
NOTE:
If the user intends to use the out-of-the-box functionality, do not to use
Slot 3 for tuner cards; otherwise Slot 3 uses source connections 5 and 6.
Begin the card insertion procedure with these steps:
1.
Disconnect power from the Adagio Entertainment System.
2.
Remove the slotted screws securing any cover plate that may be
fastened the slot you intend to use. Set the screws and the cover plate
aside.
3.
Unpack the ATC-AMFMSR card.
4.
As shown in the photo following this step, position the ATC-AMFMSR
card so the print on the faceplate is right side up and the side rails of the
card slide into the plastic slots mounted on the left and right inside
walls of the Adagio Entertainment System.
Summary of Contents for Adagio ATC-AMFMSR
Page 4: ......
