DO
GUIDE
DOC. 7712A (2042353) 01.15
Specifications subject to change without notice.
DO
Install the Speaker
CAUTION:
Do not connect the audio source to ac power until all speaker connections are
completed.
1. Use the supplied waterproof wire nuts to connect the speaker wires to the audio source
cable as shown in the hookup table and diagram below. Also, use the waterproof wire nuts
to terminate any loose (unconnected) wires.
NOTE:
Verify that the speaker operates properly prior to placing it in the ground. During
this operation check, listen for sounds resembling air leaks around the speaker perimeter,
which would indicate that the cover is not tight enough in those areas. Recheck the screw
tightness in the areas where an air leak sound is heard.
2. Insert the 12 supplied plugs (labelled C in the assembly diagram on the previous page)
securely into the screw holes.
3. Place the speaker in the hole and cover it using the soil removed earlier.
DO
Learn More
Visit the website for additional information.
Crestron Electronics
15 Volvo Drive, Rockleigh, NJ 07647
888.CRESTRON | www.crestron.com
As of the date of manufacture, the product has been tested and found to comply with specifications for CE marking.
Federal Communications Commission (FCC) Compliance Statement
This device complies with part 15 of the FCC Rules. Operation is subject to the following conditions:
(1) This device may not cause harmful interference and (2) this device must accept any interference received, including interference
that may cause undesired operation.
Caution:
Changes or modifications not expressly approved by the manufacturer responsible for compliance could void the user’s
authority to operate the equipment.
Note:
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the
FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.
This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not
occur in a particular installation.
If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna
• Increase the separation between the equipment and receiver
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected
• Consult the dealer or an experienced radio/TV technician for help
Industry Canada (IC) Compliance Statement
CAN ICES-3(B)/NMB-3(B)
The specific patents that cover Crestron products are listed at
.
Product warranty can be found at
.
Crestron, the Crestron logo, and Air are either trademarks or registered trademarks of Crestron Electronics, Inc. in the United States and/or other countries. Other trademarks, registered
trademarks, and trade names may be used in this document to refer to either the entities claiming the marks and names or their products. Crestron disclaims any proprietary interest in the
marks and names of others. Crestron is not responsible for errors in typography or photography.
This document was written by the Technical Publications department at Crestron.
©2015 Crestron Electronics, Inc.
Input Type
Input+
Input -
Tie
Low Z, 8 Ohm
Red
Black
N/A
70 V, 75W
Purple
Black
Yellow to Red
70 V, 150 W
Orange
Black
Yellow to Red
100 V, 75 W
N/A
N/A
N/A
100 V, 150 W
Purple
Black
Yellow to Red
Red
Yellow
Orange
Purple
Black
AIR_IGS82
Cable
