CRESTRON
Operations Guide - DOC. 8094B
Series 3000 Touchpanels
••
7
Installation/Setup
Identity Code
Every equipment and user interface within the CRESNET II network requires a
unique identity code (ID CODE). These codes are recognized by a two-digit
hexadecimal number from 03 to FE. Refer to “Configuring the Touchpanel” on
page 9 for instructions on setting the unit's ID CODE. The ID CODE of the unit
must match the ID CODE specified in the CRESNET II SIMPL-I program. Refer to
“Programming” on page 15 for an example of SIMPL-I program.
Recommended Cleaning
Keep the surface of the touchscreen free of dirt, dust, or other materials that could
degrade optical properties. Long term contact with abrasive materials can scratch
the surface which may detrimentally affect image quality.
For best cleaning results, use a clean, damp, non-abrasive cloth with any
commercially available non-ammonia glass cleaner. Bezels may not provide a
complete water-tight seal. Therefore, apply cleaning solution to the cloth rather
than the surface of the touchscreen. Wipe touchscreen clean and avoid ingress of
moisture beneath panels.
Preparation for Use
The only preparation that may be required is to mount the touchpanel. If a lectern
mount Series 3000 touchpanel is being installed, the cutout dimensions are
required. Refer to the lectern cutout details below for these configurations. Cutout
measurements in the figure have been rounded up to the nearest 1/8 inch.
Lectern Cutout Detail for Series 3000 Touchpanels
If the tiltcase configuration is being mounted to a flat surface, locate the mounting
holes on the “foot” of the touchpanel. Refer to the mounting details, shown after
this paragraph. Mount the touchpanel with four #6-32 hardware (not supplied).
