Camera Interface, Digital Servo Pan Tilt Head
Crestron
C2N-CAMIDSPT
10
•
Camera Interface, Digital Servo Pan Tilt Head: C2N-CAMIDSPT
Operations Guide - DOC. 6262A
•
Pressing the joystick to the right either pans the camera head to the left
or adjusts the lens focus.
•
Pressing the joystick up either tilts the camera head down or adjusts the
zoom lens.
•
Pressing the joystick down either tilts the camera head up or adjusts the
zoom lens.
To access the mini joystick, use a small screwdriver or similar flat-bladed device to
pry up the dust cover. Use care to avoid scratching the CAMIDSPT housing.
When operating the local joystick, the green LED to the right of the joystick will
blink rapidly for about 10 seconds following the last joystick operation. During this
time, communications with the Cresnet network are not active. Before powering
down, the unit should be allowed to exit local mode operation. The green LED will
blink at a slower rate.
Mini Joystick Location/Operation
CRESTRON
C2N-CAMIDSPT
RS-232
LENS
– NET –
24 Y Z G
PWR
NET SETUP
Push to
Change
Modes
PAN LEFT/
FOCUS
TILT UP/
ZOOM
PAN RIGHT/
FOCUS
TILT DOWN/
ZOOM
5-Position Mini-Joystick
(Dust Cover Removed)
Green
LED
Industry Compliance
As of the date of manufacture, the C2N-CAMIDSPT has been tested and found to
comply with specifications for CE marking and standards per EMC and
Radiocommunications Compliance Labelling.
NOTE:
This device complies with part 15 of the FCC rules. Operation is subject to
the following two conditions: (1) these devices may not cause harmful interference,
and (2) these devices must accept any interference received, including interference
that may cause undesired operation.