Crestron
C2N-CAMIDSPT
Camera Interface, Digital Servo Pan Tilt Head
Operations Guide - DOC. 6262A
Camera Interface, Digital Servo Pan Tilt Head: C2N-CAMIDSPT
•
17
cause the pan hub base to bind and will void the warranty. Refer to the
following diagram for hole location and mounting orientation.
NOTE:
If longer screws (than the ones supplied) are required to mount the
CAMIDSPT with attached camera/lens assembly, only allow eight turns into the
unit’s thread insert. More turns may disable the CAMIDSPT from panning.
Pan Hub Mounting Base
3.0 in (7.62 cm) BHC
(bolt hole circle)
For maximum pan range, camera points in
either direction with hub in ‘home’ position.
Fixed
Hard Stop
Notch for installing
adjustable stops
Adjustable
Hard Stops
Hardware Hookup
Refer to the hookup diagram below. Other than making the power connection last,
complete the connections in any order.
NOTE:
To ensure safe operation of the CAMIDSPT, all cables around the unit
must be properly “dressed” so that the cables do not strike surrounding surfaces or
equipment which would endanger safe system movement when in operation. Use the
supplied 4-inch cable tie to secure the cables to the Cable Tie Mount on the side of
the CAMIDSPT to prevent strain on the interface connections.
Hookup Connections for CAMIDSPT
CRESTRON
C2N-CAMIDSPT
RS-232
LENS
– NET –
24 Y Z G
PWR
NET SETUP
CRESNET:
TO CONTROL
SYSTEM
AND OTHER
CRESNET
DEVICES
SETUP:
FOR TOUCH-
SETTABLE
CRESNET ID
LENS:
FOR ZOOM,
FOCUS, AND
IRIS CONTROL
RS-232:
FOR SERIAL-PORT-
CONTROLLED
CAMERAS
PLUG-IN
PERSONALITY
BOARDS
Cable Tie Mount
Use a Phillips screwdriver to remove the screws securing the cover plate over the
connector for the personality boards. Verify that the personality board appropriate
