Crestron
C2N-CAMIDSPT
Camera Interface, Digital Servo Pan Tilt Head
Operations Guide - DOC. 6262A
Camera Interface, Digital Servo Pan Tilt Head: C2N-CAMIDSPT
•
31
File Transfer | Send Program Command
3. The “Send Program” window appears, as shown after this step. Click
Browse
, locate the compiled file (.spz for PRO2), and click
Open
. This
will display the program's header information and enable one or both of
the
What to Send
check boxes. If the program does not contain any
SIMPL+ modules, only the
SIMPL Program
check box will be
enabled. If it does contain SIMPL+ modules, then the
SIMPL+
Program(s)
check box will also be enabled. Select one or both check
boxes and then click
Send Program
to begin the transfer.
NOTE:
Refer to the respective Operations Guide for the control system for details
about the other fields shown on the “Send Program” window.
“Send Program” Window
4. To verify that the program has been transferred successfully, select
Diagnostics
|
Report Program Information
. This should display a
window that provides details about the current program loaded into the
control system.
Firmware Upgrade
A firmware upgrade file has
the extension .upg.
To take advantage of all the CAMIDSPT features, it is important that the unit
contains the latest firmware available. Please check the Crestron website for the latest
version of firmware. Not every product has a firmware upgrade, but as Crestron
improves functions, adds new features, and extends the capabilities of its products,
firmware upgrades are posted. Upgrading the CAMIDSPT firmware requires
Viewport version 3.94 or later. To upgrade the firmware, complete the following
steps.
1. Make sure that “Communication Settings” that begins on page 28 has
been performed.
2. As shown after this step, select
File Transfer | Update Network
Device Firmware
from the Viewport menu.