Crestron C2N-DEMO, Reference Manual

Crestron 

C2N-DEMO Lighting Case

Demonstration 

Case

Button 5 (MUSIC) 

This button toggles the audio system in the common areas of the virtual home on and 
off. The feedback LED illuminates when the audio system is active. 

Button 6 (VOL +) 

This button increases the volume level of the virtual audio system. The feedback 
LED illuminates only while the button is pressed. 

Button 7 (SRC) 

This button cycles through the various virtual audio sources. The feedback LED 
illuminates only while the button is pressed. Audio WAV files are triggered with the 
selection of each new source. This demonstrates how even a simple interface such a 
keypad can give detailed feedback information.  

Button 8 (VOL -) 

This button decreases the volume level of the virtual audio system. The feedback 
LED illuminates only while the button is pressed. 

C2N-DB12 (Entry)

1.532

MP3

1.788

1.067

1.696

4.

1

58

VOL -

OFF

CD

2.

6

96

VOL +

XM

PATH

LOWER

LAMP

RAISE

DOWN

FAN

This interface was programmed as the primary control point for the entry. The entire 
virtual house can be monitored from the web page project associated with this 
system.  

Button 1 (DOWN) 

[BM = Dim, FB = Toggle, Loads = Downlights] 

On press 1, this button turns the load to a preset level and then off again on press 2. 

Button 2 (FAN) 

This button turns on the fan and selects various speeds. The first press sets the fan to 
speed 4, the second press to speed 3, then to speed 2, speed 1, and finally back to the 
off state. The feedback LED illuminates whenever the fan is on.  

Reference Guide – DOC. 6282 

Crestron Demonstration Case: C2N-DEMO Lighting Case  

•

  15