Multi-Type Network Distribution Block
Crestron
C2N-HBLOCK
connection into the Cresnet connector and tighten the retaining screw.
Repeat the procedure for the other three conductors.
Connecting the C2N-HBLOCK to Cresnet
Devices
CAUTION: Do not connect or daisy-chain more than one power
input (power pack or power supply) to the C2N-HBLOCK. Multiple
power inputs may damage one or more power packs and/or power
supplies.
CAUTION:
Crestron modular cables are rated for a maximum of
two
(2)
amperes. Do not exceed this current capacity for any modular device.
If more current is required, connect an appropriate external power pack to
the modular device.
NOTE:
When using the C2N-HBLOCK to output power to other
devices, do not exceed the maximum capacity of the power pack or
power supply. Calculate and add the total power requirements for all
devices drawing power from the C2N-HBLOCK. If necessary, use
additional C2N-HBLOCKs and power packs or power supplies.
NOTE:
When installing network wiring, refer to the latest revision of
the wiring diagram(s) appropriate to your specific system configuration,
available from the Downloads | Product Manuals | Wiring Diagrams
section of the Crestron website (www.crestron.com).
NOTE:
Use only Crestron modular cables when making connections to
the C2N-HBLOCK modular ports. DO NOT use standard, modular
6-conductor telephone cables. Most telephone cables are wired in a
crisscross fashion and are not compatible with Crestron equipment.
8
•
Multi-Type Network Distribution Block
Operations & Installation Guide – DOC. 8157A
