Crestron
C2N-MMS-SC
Scan Converter Card for C2N-MMS
Industry Compliance
As of the date of manufacture, the card has been tested and found to
comply with specifications for CE marking and standards per EMC and
Radiocommunications Compliance Labelling (N11785).
NOTE:
This device complies with part 15 of the FCC rules. Operation is
subject to the following two conditions: (1) this device may not cause
harmful interference, and (2) this device must accept any interference
received, including interference that may cause undesired operation.
Installation and Hookup
The C2N-MMS-SC scan converter card is designed for installation into a
dedicated expansion slot on the C2N-MMS multimedia switch. The only
tools required for installation are a #2 Phillips screwdriver and a
grounding strap (or grounded workstation).
CAUTION:
The C2N-MMS-SC and the C2N-MMS contain electro-
static discharge (ESD) sensitive devices. Perform the following
procedure while wearing a grounding strap that is properly grounded and
on a grounded workstation to avoid damaging the C2N-MMS-SC card
and/or the C2N-MMS.
CAUTION:
To prevent stripping of screw heads, threads, or mounting
holes,
DO NOT
overtighten screws. Tighten only to the specification
listed in the individual step(s).
1. To prevent errors when re-connecting, label and disconnect all
cables (if) attached to the C2N-MMS’ rear ports.
2. Using a #2 Phillips screwdriver, loosen and remove the
16
screws that secure the C2N-MMS cover. Refer to the following
diagram for screw locations.
Operations & Installation Guide - DOC. 6138
Scan Converter Card for C2N-MMS: C2N-MMS-SC
•
5
